Micanan PRO-H Manuel d'instructions télécharger pdf (Page 24)

DIPSWITCH SETUP

Dip-switch

OFF

NOTE

SEQ/COM

Single button and

radio in SEQ mode

Single button and

radio in COM mode

Mid-stop

timer

Timer is enabled

from mid-stop only

Timer is enabled

from both mid-stop

and full open

T or TS mode must be

selected to enable a timer

for mid-stop

Delay on

reverse

Delay on reverse is

1.5 seconds

Delay on reverse is

0.5 seconds

Micanan recommends 1.5

sec delay on reverse for all

applications

Motor

direction

Reverse motor

direction

Standard motor

direction

See Note ** below

NOTE: If motor direction is reversed, the open and close limit switches are automatically reversed. However, the advanced

close limit switch needs to be manually changed. To do this, disconnect the 2 wires from the advanced closed limit switch

and re-connect to the auxiliary limit switch provided.

STATUS LED

LED

Status

Cause

Fault

-Primary safety devices not connected to P1 & P2

or not functioning properly

- Safety devices are activated

- 10k Ohm resistor (between S1 & S2) removed or

faulty

Fault

Blinking

- Interlock is activated.

- Interlock jumper is not connected.

Run-out timer

- Run-out timer has elapsed

Delay on close timer

Blinking

- Delay on close timer is counting.

- Selector dial is set to Run-timer.

Timer to close

Blinking

Timer to close is counting.

Safety/Photo

-Primary safety devices not connected to P1 & P2

or not functioning properly

- Safety devices are activated

- 10k Ohm resistor (between S1 & S2) removed or

faulty

Mid. Stop

Door is at Mid-stop position.

Close Limit

Close limit switch is activated.

Open Limit

Open limit switch is activated.

Stop PB

OFF

Stop button connected and functioning

- Stop push button is activated (or stop circuit is

open).

Close Relay

Blinking

- Door is closing.

- Close relay is activated.

Open Relay

Blinking

- Door is opening.

- Open relay is activated.

Power

24 VAC power to logic board is ON.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Micanan PRO-H Manuel d'instructions Page 24

Commentaires sur ces manuels

Produits connexes et manuels pour Ouvreur de porte de garage Micanan PRO-H