Micanan PRO-TB Manuel du propriétaire Page 5

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 14
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 4
5
With door several feet from closed position, disable sensing edge
TEST CLOSED DOOR CHECK:
connection to the Transmitter by one of the following methods:
- (D5) "Edge Activation" (AMBER) LED will light for several seconds.
When door closes completely:
D7D8D5D6
- (D8) "Signal Acquired" (GREEN) LED will lite when edge is pressed.
Hold closed door control:
- 2 LED's under the label will be lit.
The unit will be in "Supervised Mode":
POWERING THE RECEIVER.
THE TRANSMITTER IS IN MOTIONLESS "SLEEP" MODE BEFORE
NOTE: MAKE SURE TRANSMITTER BATTERY IS DISCONNECTED OR
INITIAL POWER UP:
START UP / TESTING PROCEDURES
D6 GREEN
D5 AMBER
D8 GREEN
D7 RED CHECK BATTERY
SIGNAL ACQUIRED
EDGE ACTIVATION
NORMAL MODE
LED LEGEND-RECEIVER
TRANSMITTER
(ON BOTTOM BAR)
RECEIVER
(ON OPERATOR)
Constant pressure required on door CLOSE control
- (D3) "Transmitter Awake" (GREEN) LED will lite when door is in motion.
1)
2)
3)
1)
Pneumatic/Air Edge:
- Remove air tube from air switch on Bottom Bar
Electrical Edge:
- Unplug quick disconnect plug connecting
2) Close door completely
Unit should switch to "Supervised Mode":
Constant pressure required on door CLOSE control.
LED LEGEND-TRANSMITTER
TRANSMITTER IN MOTION
GREEND3
"AWAKE"
Transmitter to Sensing Edge.
GAGR
NOTE: Closed limit and/or air switch (if applicable) may need adjustment
to ensure that edge is activated when door is fully closed. See Installation
Instructions for the door and operator for adjustment procedure.
4) Receiver will switch to "Normal Mode":
- (D6) "Normal Mode" (GREEN) LED will light.
Door now requires momentary contact for CLOSE control.
- (D7) "Check Battery" (RED) LED should not be lit.
- (D6) "Normal Mode" (GREEN) LED will turn off.
Vue de la page 4
1 2 3 4 5 6 7 8 9 10 ... 13 14

Commentaires sur ces manuels

Pas de commentaire