Micanan PRO-TB Manuel du propriétaire télécharger pdf (Page 6)

3) Check the Battery voltage first. (The Receiver can not tell the difference between a dead battery and a

bad edge) Minimum 7 Volts. Replace battery if voltage is at or below minimum.

2) Make sure that the limits are adjusted so the safety edge impacts the floor hard enough to activate the

safety edge on CLOSE. (The Transmitter must send a signal to the Receiver at the bottom of the opening

for the unit to function properly during the next cycle)

DIP SWITCH CONFIGURATIONS

RECEIVER SWITCH SETTINGS

12345

OFF (0) OFF (0)

54321

TRANSMITTER SWITCH SETTINGS

6 7 8

TROUBLESHOOTING

1) Verify address selection dip switches (1 thru 4) are set the same on the Transmitter and Receiver.

ADDRESS

SELECTOR

ADDRESS

FACTORY SET

DO NOT ADJUST

Open door several feet - Verify that unit is still in "Supervised Mode". Constant3)

Reconnect sensing edge to Transmitter.4)

5) Close door completely:

Unit will switch to "Normal Mode" (within 3 sec).

- (D6) "Normal Mode" (GRN) LED will light. Door now requires momentary

contact for CLOSE control.

pressure required on door CLOSE control.

4) Verify that the extra, dedicated Auxiliary Close Limit Switch is adjusted so that it trips less than 6" off

the floor. If not adjusted correctly the unit will not remain in "B2", "Normal" mode.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Pas de commentaire

Micanan PRO-TB Manuel du propriétaire Page 6